Tailgate Bike Pad, 53" Truck Tailgate Pad Carry 5 Mountain Bikes, Upgraded Grooves Tailgate Protection Pad With Reflective Strips And Tool Pockets, With Camera Opening For Mid-Size Pickup Trucks

Stop making multiple trips to the trailhead. The Vevor 53" Tailgate Bike Pad lets you load up to five mountain bikes onto your mid-size pickup in one shot — no scratched paint, no loose bikes, no wasted time. COMPATIBILITY The Vevor 53-inch tailgate bike pad is engineered specifically for popular mid-size pickup trucks, including the Toyota Tacoma, Ford Ranger, Chevrolet Colorado, GMC Canyon, Nissan Frontier, and Honda Ridgeline. The 53-inch width spans most standard mid-size tailgates, which typically measure between 50 and 53 inches across. The integrated hook-and-strap retention system wraps securely around the tailgate, holding the pad firmly in place at highway speeds and on rough dirt roads alike. A dedicated camera cutout preserves your factory backup camera function so you never sacrifice safety or visibility while hauling bikes. Before ordering, measure your tailgate's outer width to confirm fitment — this pad is purpose-built for mid-size platforms, not full-size trucks. KEY BENEFITS • 5-Bike Capacity: Upgraded groove channels machined into the top edge separate and cradle up to five bike frames simultaneously, preventing contact between frames and keeping every bike scratch-free from parking lot to trailhead. • Full Tailgate Protection: A thick foam core wrapped in rugged Oxford fabric absorbs impact from bike frames, handlebars, and pedals, shielding your truck's tailgate finish from dents, paint chips, and abrasion damage. • Reflective Safety Strips: High-visibility reflective strips run across the face of the pad, dramatically increasing your truck's rear visibility during pre-dawn or after-dark loading sessions — a feature often missing on budget pads. • Integrated Tool Pockets: On-board storage pockets keep tire levers, multi-tools, CO2 cartridges, and trail snacks within arm's reach so your gear stays organized and off the ground. • Backup Camera Cutout: A precisely placed opening aligns with the factory backup camera on compatible trucks, so you retain full rearview camera functionality with the pad installed. • Fast No-Tool Install: The strap-and-buckle attachment system goes on or comes off in under two minutes without any drilling, hardware, or tools — swap it between trucks in seconds. TECHNICAL SPECS • Pad Width: 53 inches — designed to fit most mid-size pickup tailgates 50–53 inches wide • Bike Capacity: Up to 5 mountain bikes simultaneously • Groove Channels: Upgraded separated groove design along top edge for individual bike frame cradles • Outer Shell Material: Heavy-duty Oxford fabric (600D equivalent) for weather and abrasion resistance • Inner Core: High-density foam for impact absorption and tailgate surface protection • Safety Feature: Reflective strips across pad face for low-light rear visibility • Storage: Multiple integrated tool pockets on pad face • Camera Compatibility: Integrated cutout aligned for factory backup cameras on mid-size trucks • Attachment: Adjustable hook-and-strap system with buckle closures — no tools required • Price Point: Under $54 shipped MATERIALS & BUILD QUALITY The Vevor tailgate bike pad doesn't cut corners where it counts. The outer shell is constructed from heavy-duty Oxford fabric — a tightly woven synthetic textile recognized for its resistance to abrasion, moisture, and UV exposure. This is the same class of material used in quality tool bags and outdoor gear, chosen here specifically because it holds up against the constant friction of bike frames, muddy tires, and trail grit. Underneath the Oxford shell, a thick high-density foam core provides the real protection: it compresses under load to cushion impact energy, then rebounds to maintain its shape trip after trip. The stitching along the perimeter and pocket edges uses reinforced thread at stress points, resisting the tearing and fraying that cheaper single-stitch pads suffer after a season of use. Reflective strip material is heat-bonded onto the fabric face for a secure, long-lasting bond that won't peel in heat or rain. The result is a pad that looks and performs like gear that cost significantly more. INSTALLATION GUIDE Getting this pad onto your tailgate takes less time than loading the bikes. Start by dropping your pickup's tailgate to its fully open horizontal position. Unfold the Vevor bike pad and orient it so the groove channels face upward and the camera cutout aligns with your truck's backup camera lens — hold the pad against the tailgate face to confirm alignment before securing. Next, route the top strap hooks over the top edge of the tailgate and let them hang inside the truck bed. Pull the bottom straps down and around the underside of the tailgate, then thread them through the buckle closures. Pull each strap snug and click the buckle — work from the center outward to distribute tension evenly across the pad. Give the entire pad a firm tug from multiple points to verify it isn't shifting. Finally, load your first mountain bike by setting the down tube or top tube into one of the groove channels, then lean the bike against the pad with the front wheel hanging over the bed side. Repeat for each subsequent bike, spacing them evenly across the five channels. A bungee cord or soft tie-down strap looped through the groove channels and around the bike frames adds extra security for highway runs. WHAT'S IN THE BOX • 1x Vevor 53-inch tailgate bike pad • Integrated strap-and-buckle attachment hardware (pre-attached) • Hook straps for tailgate top-edge retention WHY SHOP WITH US We stock purpose-specific truck accessories chosen for real working owners — not filler catalog products. Every item we carry is vetted for fitment accuracy, build quality, and genuine value at its price point. The Vevor tailgate bike pad earns its place in our catalog because it delivers professional-grade features — reflective strips, camera cutout, groove channels, tool pockets — at a price under $54 that most branded competitors can't touch. When you order from us, you get fast US-based processing, clear product information, and a support team that actually knows trucks. If there's a fitment question before you buy or an issue after delivery, we're here to sort it out quickly. ADD IT TO YOUR CART TODAY Your crew's bikes deserve better than bungee cords and a bare tailgate. Order the Vevor 53" Tailgate Bike Pad now and arrive at the trailhead with five bikes loaded, your paint intact, and your backup camera fully operational. At under $54, this is one of the smartest additions you can make to your mid-size pickup this season.