4-FOLD 5.5' Soft Tonneau Cover For F150 15-22 Ford F-150 F150 Truck 5.5FT Bed--A86313-20301M32101YF

Protect your F-150's bed and sharpen its look with the Mankee 4-Fold Soft Tonneau Cover built specifically for 2015-2022 Ford F-150 trucks with the 5.5-foot bed. Whether you haul tools to a job site or gear to the trailhead, this cover keeps your cargo dry, secure, and out of sight without slowing you down. COMPATIBILITY This tonneau cover is engineered to fit the 2015, 2016, 2017, 2018, 2019, 2020, 2021, and 2022 Ford F-150 equipped with the standard 5.5-foot (66-inch) short bed. It is compatible across all cab configurations — Regular Cab, SuperCab, and SuperCrew — as long as the bed length measures 5.5 feet. It does NOT fit F-150 trucks with 6.5ft or 8ft beds, nor does it fit F-250, F-350, or any other Ford model. Always verify your bed length before ordering by measuring from the inside of the bulkhead to the inside of the tailgate. BENEFITS • All-Weather Cargo Protection: The heavy-duty vinyl top panels repel rain, snow, and road grime, keeping your tools, camping equipment, and valuables dry through every season. • Enhanced Fuel Economy: The aerodynamic low-profile design reduces drag at highway speeds, which can meaningfully improve fuel efficiency compared to driving with an open bed. • Full Bed Access in Seconds: The 4-panel folding design lets you fold the cover completely forward in under 30 seconds, giving you 100% bed access whenever you need it. • Security Without a Lock Haul: The built-in clamp-and-latch system keeps the cover tightly sealed so opportunistic theft is made significantly harder without adding complicated hardware. • Clean OEM-Style Appearance: Matte black finish and low-profile aluminum side rails give your F-150 a clean, factory-look upgrade that complements any trim level from XL to Platinum. • No Drilling Required: The clamp-on mounting system attaches directly to your existing bed rails without permanent modification, preserving your truck's resale value. TECHNICAL SPECIFICATIONS • Compatible Bed Length: 5.5 ft (66 inches) • Compatible Vehicle: 2015-2022 Ford F-150 (13th Generation) • Fold Style: 4-Panel (quad-fold) soft folding • Cover Surface Material: Heavy-duty marine-grade vinyl • Frame Material: Aircraft-grade aluminum alloy rails and cross-bows • Mounting System: Clamp-on, no-drill installation • Folded Panel Clearance: Approximately 7 inches when fully folded forward • Finish: Matte black • Seal Type: Foam weatherstripping seal on all four sides • Tailgate Compatibility: Works with the factory F-150 tailgate; tailgate can be opened with cover in any position MATERIALS & BUILD QUALITY The Mankee soft tonneau cover is built around a dual-material construction philosophy: strength where it matters, flexibility where it counts. The top panels are stitched from heavy-duty marine-grade vinyl — the same class of material used in boat covers and outdoor equipment designed to withstand sustained UV exposure, temperature swings from desert heat to sub-zero winters, and repeated water contact without cracking, fading, or delaminating. The internal skeleton consists of aircraft-grade aluminum alloy cross-bows and side rails that resist corrosion and maintain their shape under load. The seams are double-stitched with UV-stabilized thread, and a continuous closed-cell foam weatherstrip gasket runs the full perimeter of the cover to create a consistent, weather-resistant seal against the bed rails and tailgate header. The result is a cover that feels substantial, opens and closes smoothly after thousands of cycles, and holds its structural integrity through years of daily use on working trucks. INSTALLATION GUIDE Installing the Mankee 4-fold soft tonneau cover requires no drilling, no special tools, and typically takes one person about 20-30 minutes. Here is a step-by-step overview: Step 1 — Unbox and Inventory: Lay all components on a clean, flat surface. Confirm you have the two side rails, front header bar, cross-bow panels with vinyl attached, mounting clamps, and all hardware listed in the box. Step 2 — Position Side Rails: Set the aluminum side rails into the top inside lip of your F-150's bed rails, one on each side. Slide them forward until the front stop contacts the cab bulkhead. Step 3 — Attach Mounting Clamps: Slide the provided clamps into the pre-drilled slots on the underside of each rail. Space them evenly — typically three clamps per side — and hand-tighten the bolts to hold rails in position without fully locking them yet. Step 4 — Install Front Header Bar: Clip the front aluminum header bar across the leading edge of both side rails at the cab end. Confirm it sits flush and level. Step 5 — Unfold and Position the Cover: Unfold the tonneau cover panels onto the rails and slide the front panel into the header bar channel until it clicks into place. Step 6 — Final Clamp Tightening: Using the supplied tool or a 10mm wrench, fully tighten all clamps to snug — do not overtorque. Check that the side rails are parallel and the cover lies flat. Step 7 — Adjust Weatherstrip and Test: Run your hand along all four edges to confirm the foam seal contacts the bed evenly. Open and close the cover several times to verify smooth operation and proper latch engagement at the tailgate end. WHAT'S IN THE BOX • 1x 4-fold soft tonneau cover with pre-attached vinyl panels • 2x Aluminum side rails • 1x Front header bar • 6x Mounting clamps with hardware • 1x Installation instruction sheet • 1x Small parts hardware bag (bolts, nuts, washers) WHY SHOP WITH US We specialize in truck accessories and fleet-grade components for working vehicle owners across the United States. Every product in our catalog is vetted for fitment accuracy and priced to deliver real value — not inflated MSRP with a fake discount. Our customer support team knows trucks, not scripts, so when you have a fitment question or need post-purchase help, you get a real answer fast. We process orders quickly, provide tracking from dispatch, and back every purchase with a straightforward return process. Thousands of F-150 owners have trusted us for their bed cover needs, and we intend to keep earning that trust one order at a time. READY TO UPGRADE YOUR F-150? Don't leave your cargo exposed to the next rainstorm. The Mankee 4-Fold Soft Tonneau Cover for 2015-2022 Ford F-150 5.5ft beds is in stock and ready to ship. Add it to your cart now and get the weather protection, security, and clean look your truck deserves — no drill required.